5.1004.8641.0 B
1-4 Safety
• SWITCH OFF the machine, disconnect and isolate the electrical power supply, release pneumatic
pressure and wait for all moving parts to stop before you do work on the machine.
• Take extreme care when you work near or with high-pressure pneumatic systems. If possible,
depressurize the system before you do work on it.
• Wear protective clothing and safety goggles when you do work on the pneumatic system.
• Wear protective gloves and safety goggles when you do work on parts where disinfective and cleaning
fluids flow through.
• Make sure all covers and guards are installed when maintenance work is complete.
• Some parts (vacuum pump, pura, parts where cleaning fluid flows through) can have a hot surface.
Make sure they are cooled down before you do maintenance.
• Do not climb on the machine.
• Always use a proper scaffold or a double sided ladder when you do maintenance on the machine.
• Block the cow traffic to the robot unit when you do maintenance on the cow side of the robot unit.
1.2 Signal Icons
Note the use of the signal words DANGER, WARNING and CAUTION with the safety messages. The signal
word for each message uses the following guidelines:
Danger
Indicates a hazardous situation which, if not avoided, will result in
death or serious injury.
Warning
Indicates a hazardous situation which, if not avoided, could result in death or serious
injury.
Caution
Indicates a hazardous situation which, if not avoided, could result in minor or moderate
injury.
in n o vato rs in agriculture
To Next Page
Loading...
Need help?
General