Appendix
11-67
BA9300SU EN 2.1
P
Packing list, 1-1
Parameter
Change, 7-10
Copy parameter sets. See Parameter set transfer
Keypad, 7-7
Load parameter set, 7-12
Parameter classes, 7-2
Parameter set transfer, 7-14
PC program, 7-1
Setting, 7-7
Structure of a parameter set, 7-2
Ways of parameter setting, 7-1
Parameter set transfer, 2-2
Parameter setting, 7-1
PC program, 7-1
Global-Drive-Control, 11-1
Power connections, 4-13
Max. permissible cross-sections
for mains connection, 4-13
for motor connection, 4-17
Process controller adaptation, 11-28
Process input words, 11-42
Process output words, 11-42
Protection against contact, 4-10
Protection against inverse polarity, 4-20
Protection of devices, 2-2
Current derating, 6-3
Protection of persons, 2-2, 4-9
Insulation, 4-10
Residual-current circuit breaker, 4-9
Punching, 4-3
Q
QSP deceleration time, 11-23
R
Rated data
200 % overcurrent, 3-4
Cable cross-sections, 3-6
Fuses, 3-6
Mains filter, 3-7
Types 9321 to 9325, 3-3
Types 9326 to 9332, 3-5
Rated motor power, 11-20
Rated motor voltage, 11-22
Reset, Fault message, 9-9
Residual hazards, 2-2
Residual-current circuit breaker, 4-9
Resolver connection, 4-31
Resolver poling, 5-5
Rotor position adjustment, 5-5
S
Safety information, 2-1
for drive inverters in accordance with the Low-Voltage Directive,
2-1
Layout, 2-2
Other notes, 2-2
Warning of damage to material, 2-2
Warning of damage to persons, 2-2
Selection lists, Signal links, 11-51
Selection motor type, 11-20
Selection of the feedback system, 11-18
Servo. See Controller
Shielding
Control cable, 4-20
EMC, 4-34
Motor cable, 4-15
Speed control, 11-2, 11-5, 11-7, 11-10, 11-12
State bus, 4-25
Status indications
Global-Drive-Control, 6-1
Keypad, 6-1
Status messages, 9-1
Status word, 9-2, 11-24
Switching on the motor side, 4-17
Synchronous motors, Rotor position adjustment, 5-5
To Next Page
Loading...
Need help?
General
