9. Firmware Update UCX series – User's Manual 137
ATTENTION!
transmitter is switched to bootload mode. Signal processing is not performed. Do not interrupt the
Introduction
Preparation
most cases.
▪ LFP2 le,
▪ LDU2 software installed on your PC or Mac.
Both can be downloaded from .
Optionally, you can download the release notes
About the Firmware Package (LFP2 File)
the update on your device.
▪
▪
▪
LDU2 Installation
ATTENTION! Minimum system requirement: 2 GB RAM.
INFO:
Download the software from .
Installation in case of Windows OS
Run the installer. If the User Account Control displays a pop-up message click Yes.
Installation Modes
Normal install Snapshot install
The installer can update
only this instance
Cannot be updated
One updateable instance
may exist for all users
Many different versions can be
installed for all users
ATTENTION! Using the default Normal install is highly recommended.
INFO: If you have a previously installed version you will be prompted to remove the old version before
installing the new one.
Installation in case of macOS #new
program into the Applications folder. If you want to copy
desired folder.
ATTENTION!
exceptions of the blocked software for the proper
operation.
INFO: This type of installer is equal with the Normal
install
Installation in case of Linux #new
Step 1. Download the archive le (tar.gz) from www.lightware.com and unpack it to a temp
folder.
Step 2. Run the install_ldu2.sh
Step 3. LightwareDeviceUpdaterV2.sh that can be used to
To Next Page
Loading...
Need help?
General
