Logicube ZClone Xi User Manual

OPTIONS
Logicube ZClone™Xi User’s Manual 76
8.4.2 PCIe Bridge Instructions
To use the PCIe Bridge:
1. Make sure the PCIe Bridge is turned OFF.
The PCIe port is not hot-swappable. Always
turn the PCIe Bridge OFF when connecting or
disconnecting drives through the PCIe port.
2. Connect a drive to the PCIe Bridge’s PCIe port.
Connect only one drive to the PCIe
Bridge. The PCIe Bridge only works
with one drive connected at any time.
3. Connect the USB 3.0 A Male to A male cable to one of the ZXi’s USB 3.0 ports and
the other end of the cable to the PCIe Bridge’s host port (on the right side).
4. Connect the AC adapter/power supply to a power source and the PCIe Bridge.
Logicube has qualified and
included a 3-foot USB 3.0
A Male to A Male cable.
5. Press and release the power button located on the top of the PCIe Bridge. The
Power LED will start blinking as the device turns on. The boot sequence may take
about 30 seconds and when finished, the Power LED will stop blinking and turn
on solid.
To disconnect or change drives, turn the PCIe Bridge
OFF by pressing and releasing the power button. Wait
for the Power LED to turn OFF. Once the PCIe Bridge
is turned off, it is safe to disconnect or change drives.
The ZXi does not need to be turned off.

Logicube ZClone Xi Specifications

General

Brand	Logicube
Model	ZClone Xi
Category	Disc Duplicator
Language	English