4 -11
1. Press down the clutch and brake pedals.
Pull the throttle lever to “Low” speed position.
Place all the transmission gear levers in
neutral and put PTO switch to “OFF” position.
3. Apply parking brake and release the brake
pedals and clutch pedal slowly.
2. Lower the implements to the ground and
turn key switch to “OFF” position.
(5) Stopping tractor
Mechanical type
1. Release the HST forward/reverse pedal
slowly, Pull the throttle lever to “Low” speed
position. Place the range gear shift lever in
neutral position and put PTO switch to “OFF”
position.
3. Apply parking brake and release the brake
pedals slowly.
2. Lower the implements to the ground and
turn key switch to “OFF” position..
HST Type
Clutch pedal
Throttle lever
Brake pedals
Key switch
Parking brake lever
Shuttle lever
PTO switch
HST reverse pedals
Brake pedals
Throttle lever
Parking brake lever
HST forward pedals
Key switch
Caution
▶ DO NOT leave the tractor with the transmission gear placed in neutral position and
the parking brake not applied. The tractor may roll down.
Apply the parking brake at all times before leaving the tractor.
▶ Remove the ignition key always after stopping engine.
To Next Page
Loading...
Need help?
General
