LS tractor MT235E 2020 User Manual

5 -31
(4) Checking Front axle oil (4WD)
 Stop the tractor on a level surface and apply the
parking brake and lower the implements to the
ground.
 Unscrew the oil gauge and check if the oil level
is between low and high marks.
 If necessary, add new oil into the oil filling inlet.
(after 5~10 minutes later, check it again)
 For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
Oil filling inlet & oil gauge
(3) Checking Transmission oil
 Stop the tractor on a level surface and apply the
parking brake and lower the implements to the
ground.
 Clean around the oil filling inlet and pull the
gauge straight out.
 Check if the oil level is between low and high
marks of the oil gauge. If necessary, add new oil.
 For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
Oil filling inlet
& oil gauge
(5) Battery check
 Refer to the chapter 5-14-(3), “Batter handling and Notices” in this manual. (See page 5-50)
(6) Air cleaner (Dry type)
 Refer to the chapter 5-6-(6) in this manual. (See page 5-24)
<Oil gauge >
High
Low
▶
The contaminated oil may reduce the durability of the power drive line and it can
cause failure of the transmission and hydraulic system. Clean around the oil filling
inlet before opening the gauge.
Caution
▶
The contaminated oil may reduce the durability of the power drive line and it can
cause failure of the front axle. Clean around the oil filling inlet before opening the
gauge.
Caution

LS tractor MT235E 2020 Specifications

General

Brand	LS tractor
Model	MT235E 2020
Category	Tractor
Language	English