5 -26
(9) Tightening state of bolts and nuts of each part
Check if the bolts and/or nuts of each part are loosened. If necessary, tighten it again. Especially,
check the bolts and/or nuts of the tires before starting engine, if necessary, tighten them.
Tighten the wheel bolts and/or nuts to the
specified torque any time you remove the
wheel assembly from the machine or loosen
the wheel bolts or nuts.
Front Wheel Torque: M16x1.5P
1800~2000 kgf.cm
(177~196N.m, 130~145 lb.ft)
▶
Roll-over hazard!
Never operate the machine with a loose wheel rim or disc. Always tighten nuts
and/or bolts to the specified torque value and at the recommended intervals.
Failure to comply could result in death or serious injury.
Warning
Rear Wheel Torque: M16x1.5P
1800~2000 kgf.cm
(177~196N.m, 130~145 lb.ft)
NOTICE: Check and tighten wheel bolts and/or
nuts to proper torque specifications after the
following hours of use:
• First 5 hours
• First 50 hours
• Every 300 hours
Wheel bolts and nuts
Wheel bolts and nuts
To Next Page
Loading...
Need help?
General
