(12) HST neutral switch (HST type)
It is located under the HST forward/reverse pedal
and the switch shall be pressed if the pedal is
placed on the NEUTRAL position as the pedal is
not pressed.
The engine does not start until the switch is
pressed.
This is the switch to prevent the tractor from
suddenly starting in forward or reverse.
Do not disassemble the HST neutral switch. It may cause sudden starting and
Do not disassemble the HST neutral switch. It may cause sudden starting and
serious injury.
▶
If the HST neutral switch does not pressed in the neutral position of the HST
forward / reverse pedal, adjust the switch to be pressed by HST pedal linkage.
warning
(13) Cruise control lever
(HST Type)
For cruise drive, push the cruise control lever
down in the state of pressing the HST pedal
forward. And then, the HST pedal shall be fixed
and the tractor can drive forward with constant
speed.
To stop the cruise drive ;
1) Press the brake pedal down or
2) Press the HST pedal forward little more.
And then, The HST pedal returns to the neutral
Cruise control lever
Cruise drive
Release
HST forward
pedal
3
3 3
3 - 14
And then, The HST pedal returns to the neutral
position and the cruise drive shall be stopped.
▶
During the cruise drive, pressing the HST pedal backward to release the cruise
drive or to reverse the tractor is NOT available. After stopping the cruise drive as
above described, press the HST pedal backward.
▶
DO NOT try to move the cruise control lever down to quit the cruise drive. It may
cause the failure of the cruise control linkage system.
warning
To Next Page
Loading...
Need help?
General
