5 -9
(2) Fuel tank
①
Using Diesel fuel
z
Use Ultra low sulfur diesel, below 15 ppm.
- ASTM D975-08a Grade 2
- EN590 : 2009 Diesel fuel
- BS2869 : 2006 Class A2
- You can use the Bio diesel fuel up to 7%
(EN590 2009, ASTM D975)
z
If contaminants like water or dusts are mixed in
the fuel, it may cause a severe damage to the
engine. The fuel storage facility must be
equipped as shown in the figure. If possible, fill
the tank at the gas station.
②
Using diesel for winter
z
General diesel fuel tends to generate paraffin
dregs in winter time which may cause a bad
engine start. Thus, it is recommended to use
specially winterized diesel in winter time.
z
If the ambient temperature is below -15
°
C(5
℉
),
it is advised to mix diesel with kerosene as
shown on the right.
③
Checking fuel level
z
Check the fuel gauge and if it’s not sufficient, fill the fuel tank with fuel.
z
Capacity : See section 5-3 in this manual
▶
After finishing work, fill the fuel tank fully. As the temperature drops down, the
humidity in fuel tank is condensed, and may be mixed with the fuel.
Notice
Temp.
≥ -15
℃
(5
℉
)
≤-15
℃
(5
℉
)
Fuel
100% Diesel fuel
for winter
20% kerosene
added
Drum
Impurities
Battery charging
indicator
Engine oil pressure
indicator
(3) Instrument panel & Indicators
z
Check if the indicators are normally turned on/off
before starting engine or while operating
frequently and periodically.
z
If the engine oil pressure indicator and battery
charging indicator are turned on while the
engine is running, stop the engine immediately
and check the engine lubrication system and
battery charging system. If possible, contact your
authorized local dealer for check.
z
For further information about indicators, refer to
the section 3 in this manual.
To Next Page
Loading...
Need help?
General
