4 -12
(2) Notices in handling new tractor
z To get the best performance, comply with the following instructions.
- DO NOT start or stop the tractor suddenly.
- DO NOT carry out heavy loaded work and DO
NOT increase the engine rpm to high speed
suddenly.
- Despite warm temperature outside, carry out
warming up the engine for approximately 5
minutes at 1500 rev/min
z After using first 50 hours,
- Replace the engine oil filter and hydraulic oil filters after first 50 hours of work, and check each
part of your tractor as reference of chapter 5-4, “First 50 hour check” in this manual.
- If possible, contact your authorized local dealer for “First 50 hour check”.
4-3. How to handle new tractor
(1) Check points
※ For new tractor, the following must be checked once again even though there was sufficient quality
management, inspection, regulating of each part in the factory.
z Appearance check
- Is there any damage while transporting?
z Engine cooling system check
- Is there anti-freeze solution in the radiator?
And any leakage?
z Fuel system check
- Is there any leakage of fuel in the fuel system?
z Oil level check
- Is there optimal oil amount in each part ?
z Electric system check
- Is there any cut-off or any other problem in the
wiring?
- Is there any problem to operate the instruments?
- Is the state of battery charging sufficient?
To Next Page
Loading...
Need help?
General
