Air Controls
The intensity of the jet action can be
controlled by altering the amount of air
injected with water through the jets. Your
spa has one or more air controls located on
the lip of the spa. Each control activates air to
specic jets in the spa allowing you to create
various combinations and levels of jet action
to suit individual preferences. Turn the control
counter-clockwise to turn the air o and
clockwise to turn air on.
NOTE: Air controls should be closed
during heating cycles for maximum
energy eciency.
NOTE: At the start of a ltration cycle, the
Optional Air System is activated to purge
the lines and ensure complete ltration.
Ensure that at least one air control is always
fully open.
On / O Valve: Turns on or shuts o the ow
of water to multiple jets or the waterfall. This
valve should be tested weekly to clean the
lines and to help prevent debris build up.
Diverter Valve: Diverts water from one set of
jets to another. This valve should be tested
weekly to clean the lines and to help prevent
debris build up.
NOTE: The diverter and on / o valve(s)
should be cleaned regularly. Remove the
handle by pulling upward and rocking it
back and forth, unscrew the cap and pull the
valve stem out. To clean the valve stem and
housing, use a pressurized hose and spray the
inside of the valve housing. Soak the valve
stem in a diluted spa cleaning solution, rinse.
Wipe the inside to remove debris.
To Next Page
Loading...
Need help?
General
