ONE-PRESS ACTIVATION
The Shortcut Screen requires no navigation.
Each button is xed on a specic fuction and
can be used as a very simple user interface for
the spa.
THE SETTINGS SCREEN
PRESSING A “BUTTON”
When instructions are given to “press a button”
any of the following can be done:
• Navigate to the desired item on any Screen.
When the desired item is highlighted, press
the Select Button.
• Press the button for that device while on the
Shortcuts Screen, if the device is one of the 4
functions available.
PROGRAMMING, ETC.
The Settings Screen is where all program-
ming and other spa behaviors are controlled.
This screen has several features that can be
acted on directly. These features include Temp
Range, Heat Mode, and Invert Panel. When
one of these items is highlighted, the Select
Button is used to toggle between two settings.
All other menu items (with an arrow pointing
to the right) go to another level in the menu.
PRESS-AND-HOLD
If an Up or Down button is pressed and held
when an item in a Menu List is highlighted,
the list can be scrolled quickly from top to
bottom. The scroll bar on the right side of the
screen indicates the relative position of the
highlighted item in the list.
DUAL TEMPERATURE RANGES
This system incorporates two temperature
range settings with independent set tempera-
tures. The specic range can be selected on
the Settings screen and is visible on the Main
Screen in the upper right corner of the display.
These ranges can be used for various reasons,
with a common use being a “ready to use” set-
ting vs. a “vacation” setting.
Each range maintains its own set temperature
as programmed by the user. This way, when
a range is chosen, the spa will heat to the set
temperature associated with that range.
High Range can be set between 80°F - 104°F.
Low Range can be set between 50°F - 99°F.
Freeze Protection is active in either range.
HEAT MODE - READY VS. REST
In order for the spa to heat, a pump needs to
circulate water through the heater. The pump
that performs this function is known as the
“heater pump.” The heater pump can be either
a 2-speed pump (Pump 1) or a circulation
pump. If the heater pump is a 2-Speed Pump
1, READY Mode will circulate water every 1/2
hour, using Pump 1 Low, in order to maintain
a constant water temperature, heat as needed,
and refresh the temperature display. This is
known as “polling.” REST Mode will only allow
heating during programmed lter cycles.
Since polling does not occur, the temperature
display may not show a current temperature
until the heater pump has been running for
a minute or two. While Pump 1 High can be
turned on and o, Pump 1 Low will run until
set temperature is reached, or 1 hour has
passed.
CIRCULATION MODE
If the spa is congured for 24HR circulation,
the heater pump generally runs continuously.
Since the heater pump is always running, the
spa will maintain set temperature and heat as
needed in Ready Mode, without polling.
In Rest Mode, the spa will only heat to set tem-
perature during programmed lter times, even
though the water is being ltered constantly
when in Circulation Mode.
To Next Page
Loading...
Need help?
General
