The selected mode will be displayed in the
LCD window of the control panel.
When in Standard mode, the letters ‘ST’ are
displayed, followed by the water temperature.
When in Economy mode, the letters ‘EC’ are
displayed alternately with the water temperature.
When in Sleep mode, the letters ‘SL’ are
displayed alternately with the water temperature.
Setting the Time and Filtration Cycles
Preset Filter Cycles. The spa control system
is designed with two lter cycles. The rst
lter cycle turns on 6 minutes after power is
supplied to the spa. The second lter cycle
turns on 12 hours later. Filter cycles are pre-set
for a two hour duration.
NOTE: To properly clean and maintain spa,
a total lter time of at least four hours per
day is recommended.
Changing Filter Cycle Start Time
The start/stop times of the lter cycle
correspond to 6 minutes after the spa set time
is established. Set time is based on the time
of day that the spa is powered up. Set time
may only be changed by disconnecting power
from the spa and re-connecting it at the
desired start time. For example, if you want
the lter cycle to begin at 9:00 PM, unplug the
spa and re-connect it at 8:54 PM (remember
the 6 minute wait period). The cycle will begin
at 9:00 PM and will repeat beginning at 9:00
AM. Each cycle will run for the prescribed
number of hours.
JETS
Touch the ‘JETS’ pad to activate the primary
ltration pump. The sequence of the jet action is:
1 touch = Low therapy jets
2 touches = High therapy jets
3 touches = O
The low speed operation of Pump 1 is timed
to automatically turn o after two hours
of operation. The high speed operation of
Pump 1 is timed to automatically turn o
after 15 minutes of operation.
NOTE: Pump 1 will automatically operate
in low speed whenever the spa calls for a
ltration cycle or heat. When this automatic
activation occurs, the low speed of Pump
1 cannot be turned o; however, all other
control functions can be activated.
Standard/Economy/Sleep Modes
Your spa can be switched among Standard,
Economy, and Sleep modes by touching the
‘TEMP’ pad and then the ‘LIGHT’ pad.
If your spa is in the Standard mode, the low
speed op Pump 1 and the heater will come on
automatically to maintain the set temperature
of the water.
If your spa is set in the Economy mode,
the heater will operate ONLY during the
ltration cycles. The pump will circulate
for approximately two minutes several
times throughout the day to sample water
temperature.
If your spa is set in the Sleep mode, the
heater and pump will operate either during
a ltration cycle or, when the heater housing
temperature drops below 45°F (7,2°C). The
spa will heat to within 20°F (11°C) of the set
temperature only during lter cycles.
To Next Page
Loading...
Need help?
General
