Temperature controls
The maximum set temperature is 104°F (40°C)
and the minimum set temperature is 80°F
(26°C). The current water temperature or, if
the pump has not been running, two dashes,
will show on the display. If dashes are
displayed, you must rst start the pump by
pressing the JETS pad. Wait until the water
temperature is displayed (approximately 2
minutes).
The set temperature of your spa may easily be
increased or decreased at any time using the
‘TEMP’ pad. Either the actual temperature or
2 dashes will be displayed. Press the ‘TEMP’
pad; the set temperature will be displayed in
the LCD window. The next touch of ‘TEMP’
will change the set temperature either up
or down 1°F (0,5°C). If you want to increase
the temperature and the displayed indicates
the temperature was increased by 1°F (0,5°C),
continue to press the ‘TEMP’ pad until the
desired set temperature is reached.
If you want to decrease the set temperature
and the LCD indicates that the temperature is
increasing, STOP. Wait a few seconds until the
actual temperature is displayed. Then press
the ‘TEMP’ pad again. The set temperature
will be displayed. Press it again and the set
temperature will decrease by 1°F (0,5°C).
Continue pressing the ‘TEMP’ pad until the
desired set temperature is reached.
If the spa is set in Standard mode or in a
ltration cycle, increasing the set temperature
may result in activating the heater. Decreasing
the set temperature will turn the heater
o. When the heater is operating, the LCD
indicator below the ‘TEMP’ icon will be lit.
User’s Pads
User’s Pads are the buttons located on the
topside control panel and are used to program
various spa functions (i.e., turn on spa light, set
temperature, etc.). The following table denes
the buttons:
Pad Use
• Decrease temperature
• Increase temperature
• Change ler durations
• Turn internal spa light
on or o
• Switch modes
• Set duration of lter
cycles
• Activate therapy pump
• Optional
• Turns blower system
on or o
• Same as Turbo
To Next Page
Loading...
Need help?
General
