Changing Filter Cycle Start Time
The start/stop times of the lter cycle
correspond to 6 minutes after the spa set
time is established. Set time is based on the
time of day that the spa is powered up. Set
time may only be changed by disconnecting
power from the spa and reconnecting it at the
desired start time. For example, if you want
the lter cycle to begin at 9:00 PM, unplug the
spa and re-connect it at 8:54 PM (remember
the 6 minute wait period). The cycle will begin
at 9:00 PM and will repeat beginning at
9:00 AM. Each cycle will run for the
prescribed number of hours.
Changing Filter Cycle Duration
The duration of a lter cycle can be set in two
hour increments of 2, 4, 6, 8, or continuous.
For example, a 2 hour cycle will complete once
every 12 hours for a total of 4 hours per day.
The amount of time needed to lter your spa
will depend on usage and ambient conditions.
You will need to program your lter cycles
based upon your personal use.
To change the duration of the lter cycles
press the ‘UP’ or ‘DOWN’ button and then
touch the ‘JETS 1’.
Press the ‘UP’ or ‘DOWN’ button to adjust the
cycle duration to the desired setting. After
each press, the duration of the cycle will be
displayed in the LED window as follows:
F2 2 Hours for each cycle, 4 hours per day
F4 4 Hours for each cycle, 8 hours per day
F6 6 Hours for each cycle, 12 hours per day
F8 8 hours for each cycle, 16 hours per day
FC Continuous ltration, 24 hours per day
To exit the lter-set procedure, touch ‘JETS 1’.
The LED window will display the current water
temperature.
If a change is made to the duration while the
spa is in a ltration cycle, it will take eect
immediately. If the change is made outside a
ltration cycle, it will take eect at the start of
the next scheduled cycle.
Note: When power to the spa is denied
(disconnect, power outage), the controls
may revert to the default factory settings.
Any adjustments to set temperature
or lter cycle duration may need to be
reprogrammed.
Note: At the start of each ltration cycle,
Pump 2 and Air Blower (if installed) are
activated for 30 seconds to clear the water
in the pipes and ensure complete ltration.
Clean Up Cycle
After periods of heavy use, you can manually
start a clean-up cycle by turning Pump 1 on in
low speed. The pump will operate for 2 hours
and then automatically turn o. The heater
can also operate during this period if the
conrols are set in the Standard mode.
Bluetooth/MP3 Stereo Option
CAUTION: Stereo/MP3/Cell Phone/Portable
Electronic Devices
Many consumers own some form of portable
electronic device, and some spas come
equipped with stereos designed to interface
with these devices. It is important to protect
a spa’s stereo equipment and your portable
electronics by following a few simple
procedures:
- Always turn the volume down on your
portable electronic device before connecting
it to the spa stereo.
- Do not attempt to handle any portable
electronic device with wet hands.
- Inspect any area for moisture before setting
your portable electronic device in or on it.
To Next Page
Loading...
Need help?
General
