Manitowoc 14000 User Manual

Reference Only
OPERATING CONTROLS AND PROCEDURES 14000 OPERATOR MANUAL
3-46
Published 03-29-17, Control # 064-23
4. In function mode screen, enter remote control data box
(Figure 3-34
).
5. Scroll up or down to turn on (I) remote control.
6. Remote control ON prompt remains in display
until it is turned off.
7. Exit remote control data box to save setting.
8. Hold down power button on remote control.
9. Move selected switch up or down to operate function.
1 – Power Switch
DEPRESS button to TURN ON power to operate remote
controls.
RELEASE button to TURN OFF power to remote controls.
2 – Stop Switch
DEPRESS knob to STOP the engine and all remote
controlled functions in an emergency only — for example: if a
function does not stop when the control is released to off or
any other uncontrolled motion of a function is observed.
Always use ignition switch in cab to stop engine for normal
operating conditions.
Beware — when knob is pushed down, engine stops and
any function being operated comes to an abrupt stop.
NOTE: The knob must be pulled UP to RESTART the
engine and operate remote controlled functions.
3 – Gantry Cylinders
Move toggle UP and hold to RAISE gantry (extend
cylinders).
Release toggle to CENTER to STOP gantry. Valves on the
cylinders lock the gantry in position.
Move toggle DOWN and hold to LOWER gantry (retract
cylinders).
Read Crane Assembly and Disassembly Instructions in
Section 4 for gantry/mast raising and lowering instructions.
4 – Back Hitch Pins
Move toggle UP and hold to DISENGAGE back hitch pins.
Release toggle to DOWN position to ENGAGE back hitch
pins.
Read Crane Assembly and Disassembly Instructions in
Section 4 for back hitch pins assembly/disassembly
instructions.
FIGURE 3-33
Item Description
1 Node-3
2W*6 Receptacle
3 Remote
2
3
1
M100003
FIGURE 3-34
Remote Control
ON
14-COM-3-23
FIGURE 3-35
P2424
3
1
4
2

Manitowoc 14000 Specifications

General

Brand	Manitowoc
Model	14000
Category	Construction Equipment
Language	English