Manitowoc Published 03-29-17, Control # 064-23 v2 4-47
14000 OPERATOR MANUAL SETUP AND INSTALLATION
Disconnect Boom Butt from Boom
1. Select Liftcrane Mast Capacities Chart in configuration
screen of RCL display.
The mast and gantry controls will not operate properly
and the mast operating limits will remain off until the
proper capacity chart is selected.
Unless otherwise specified, see Figure 4-22
for the following
procedure.
2. Disconnect electric cables as follows:
a. Disconnect cable (WBC, View E) from cable reel on
boom butt.
Connect cable (WBC) to terminating plug (1, View
B, Figure 4-8
) on rotating bed.
b. If equipped, disconnect electric cables (W33API
and W34API, View F) from front of rotating bed. Coil
cables on butt for storage.
Connect terminating plug (1, View C, Figure 4-8
) to
cable (2b) on rotating bed.
c. Coil excess cable (20, View E) onto cable reel.
d. Install dust caps on ends of all electric cables.
3. Disconnect hydraulic hoses (22, View D) from boom butt
at couplers (21). Install dust caps on ends of all
hoses and couplers.
4. Fully raise mast arms using switch in operator’s cab.
5. Disconnect mast straps from boom straps:
a. Lower mast so pins (17, View H) are loose.
b. Remove pins (17, View H) from boom straps (16).
c. Raise mast so mast straps (15) are clear of boom
straps (16).
d. Remove pins (19, View H) from storage brackets.
e. Rotate strap storage links (18, View H) to the
storage position (View G) and install pins (17)
through holes in boom straps (16) and strap storage
links (18).
f. Install pins (19, View G) in storage brackets.
6. Unpin pendants (7, View J) from storage lugs (8) on
mast (2) and pin pendants (7) to lifting lugs (9, View A)
on boom butt (1).
7. Slowly raise mast only enough to support boom butt —
so pins (14, View C) are loose.
8. Remove pins (14, View C) from holes between inserts.
9. Store pins (14, View C).
DANGER
Falling Mast/Boom Hazard!
Prevent mast from falling:
• Fully raise mast arms before raising mast. Mast will
fall over backwards if raised to vertical when arms are
down
Legend for Figure 4-22
Item Description Item Description
1 Boom Butt 18 Strap Storage Link
2 Mast 19 Pin with Cotter Pin
7 Pendant 20 Electric Cable from Cable Reel
8 Storage Lug 21 Hydraulic Couplers
9 Lifting Lug 22 Hydraulic Hoses
12 Insert W34API Electric Cable from Drum 3
14 Pin with Safety Pin W33API Electric Cable from Drum 3 Bail Limit
15 Mast Strap WBC Electric Cable from Engine Node
16 Boom Straps (on first insert)
17 Pin with Collar, Retaining Pin and Cotter Pins