EasyManuals Logo
Home>Manitowoc>Construction Equipment>14000

Manitowoc 14000 User Manual

Manitowoc 14000
270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
Reference Only
Manitowoc Published 03-29-17, Control # 064-23 3-19
14000 OPERATOR MANUAL OPERATING CONTROLS AND PROCEDURES
3
B6. Boom Pins Switch
Enable Set Up mode.
Press and hold TOP of rocker to DISENGAGE boom hinge
pins.
RELEASE rocker to ENGAGE boom hinge pins.
B7. Mast Switch
Enable Set Up mode.
Press and hold TOP of rocker to EXTEND mast arm
cylinders.
Release toggle to CENTER to STOP cylinders. Valves on the
cylinders lock them in position.
Press and hold BOTTOM of rocker to RETRACT mast arm
cylinders.
Read Crane Assembly and Disassembly in Section 4 for live
mast raising and lowering instructions.
B8. Dome Light Switch
Dome light switch is part of light fixture on ceiling of cab.
Press FRONT of rocker to TURN ON dome light.
Press REAR of rocker to TURN OFF dome light.
B9. Overhead Fan Switch
Fan has a three position switch: off, low, high. Adjust fan’s
position to direct air flow as desired.
B10. Horn Switch
A horn switch is provided on right side console. Use horn
when necessary to warn or signal personnel while crane
is being operated or serviced.
Press and hold FRONT of rocker to TURN ON horn.
RELEASE rocker to TURN OFF horn.
B11. Cab Tilt Switch
Press and hold FRONT of rocker to RAISE front of cab.
CENTER rocker to LOCK cab in position.
Press and hold BOTTOM of rocker to LOWER front of cab.
B12a. Cigarette Lighter Receptacle
Push IN to TURN ON lighter.
The lighter will pop out automatically when the coil is hot.
This receptacle can be used to power other 12 volt
components.
B12b. Power Supply Receptacle
Provided to power/charge a 12 volt cell phone or other
component.
B13. Programmable Receptacle
Programmable receptacle is for connecting laptop computer
for loading software or programming functions.
B14. Fire Extinguisher
A fire extinguisher is located behind the seat in operator’s
cab and on the crane rotating bed (optional).
B15. Radio/CD Player (optional)
See manufacturer’s instructions.
B16. Overhead Sun Shade and Tinted Visor
An overhead sun shade is provided for top window. A tinted
visor (optional) is provided for front window. Position sun
shade and tinted visor as desired to shade sunlight.
B17. Machinery Heaters
Hydraulic tank has two thermostatically controlled heaters
(120 or 240 volt) designed to keep oil temperature 30°F
(17°C) warmer than ambient temperature.
To aid engine startup in cold weather, plug in heaters at
shutdown; unplug heaters at startup.
WARNING
Falling Load Hazard!
To prevent boom or boom butt from falling off crane:
• Do not disengage boom hinge pins until boom butt is
properly supported on stands at ground level. Boom/
boom butt could fall off crane.
• Read Boom Rigging Guide in Section 4.
WARNING
Moving Cab Hazard!
Warn personnel to stand clear of operator’s cab while
tilting.
• Personnel can lose balance and fall
• Personnel can be crushed between operator’s cab
and machinery enclosure

Table of Contents

Other manuals for Manitowoc 14000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitowoc 14000 and is the answer not in the manual?

Manitowoc 14000 Specifications

General IconGeneral
BrandManitowoc
Model14000
CategoryConstruction Equipment
LanguageEnglish

Related product manuals