Manitowoc 14000 User Manual

Reference Only
Manitowoc Published 03-29-17, Control # 064-23 3-47
14000 OPERATOR MANUAL OPERATING CONTROLS AND PROCEDURES
3
Manual Controlled Handles
The speed at which jacks and pins operate depends on
control handle movement and/or engine speed. To provide
adequate speed, the engine must be operated at middle to
high idle. All control handles are spring returned to off.
On current production cranes:
• The swing/travel alarm will sound continuously
when a function is being operated with a carbody
manual control.
• Cranes meeting 2010 European requirements, the
controls in the operator’s cab and the setup remote
controls cannot be operated when a carbody
manual control is being operated.
Crawler Pin Controls
1 – Right Crawler Pin Handle and
2 – Left Crawler Pin Handle
Push handle TOWARD carbody to ENGAGE crawler
connecting pins. Crawler locking pins must be installed to
lock connecting pins in engaged position (read Crane
Assembly and Disassembly Instructions in Section 4).
Release handle to CENTER to stop pins.
Pull handle AWAY from carbody to DISENGAGE crawler
connecting pins. Crawler locking pins must be removed
before pins can be disengaged (read Crane Assembly/
Disassembly and Disassembly Instructions in Section 4).
Carbody Jack Controls
3 – Right Front Jacking Handle,
4 – Right Rear Jacking Handle,
5 – Left Rear Jacking Handle, and
6 – Left Front Jacking Handle
Push handle TOWARD carbody to RAISE carbody (extend
jack).
Release handle to CENTER to stop jack. Valves on the jack
lock it in position.
Pull handle AWAY from carbody to LOWER carbody (retract
jack).
7 – Carbody Level
Indicates crane levelness from front to rear and from side to
side while jacking the carbody. The level is mounted on the
front of the carbody (Figure 3-10
). The crane is level when
the bubble is centered in the circle. The crane is one degree
out of level when the bubble is touching the outside edge of
the circle.
FIGURE 3-36
P2384
Right Front of Carbody
1
4
5
6
3
2
WARNING
Moving Part Hazard!
Avoid serious injury:
• Keep feet clear of moving jacks
• Warn all personnel to stay clear of jacks while they
are being extended
• If remote pins or outriggers are not visible from the
control handles, use a signal person or spotter that
can ensure personnel are clear
CAUTION
Machinery Damage!
Avoid damage to carbody jacks:
• Fully retract jacks before traveling
WARNING
Tipping Hazard!
Prevent crane from tipping over.
• Keep crane level while jacking
• Do Not rely on jacking system to keep unit level.
Check level often
FIGURE 3-37
P2361
7
Shown
Approximately
One-Half Degree
Out of Level
Circle

Manitowoc 14000 Specifications

General

Brand	Manitowoc
Model	14000
Category	Construction Equipment
Language	English