Manitowoc Published 03-29-17, Control # 064-23 v2 4-67
14000 OPERATOR MANUAL SETUP AND INSTALLATION
Install Crane on Trailer
See Figure 4-30 for the following procedure.
1. Using controls (1, View A) on front of carbody (2), extend
jacks (3, View D) until carbody is high enough for trailer
(4) to be traveled under crane.
Keep crane level while jacking. Level (5, View A) is
located near controls.
2. Position trailer under crane.
3. Retract jacks (3) to lower crane onto trailer.
4. Remove jack pads (6, View E) from jacks and store jack
pads (View C).
5. Store each jack (3) as follows:
a. Fully retract jack.
b. Remove hitch pin (9, View E).
c. Swing jack in (View F).
d. Install hitch pin (9, View F).
6. Securely fasten carbody (2) to trailer (4).
7. Store mirror (10, View B) on right front corner of rotating
bed:
a. Loosen thumb screw (11).
b. Lift mirror support (12) out of outer notch in bracket
(13).
c. Rotate mirror inward and lower mirror support (12)
into inner notch in bracket (13).
d. Tighten thumb screw (11).
WARNING
Moving Part Hazard!
Avoid serious crushing injury:
• Warn all personnel to stand clear of jacks
Tipping Hazard!
Avoid tipping crane over:
• Keep crane level while jacking
To Next Page
Loading...
Need help?
General
