OPERATING CONTROLS AND PROCEDURES 14000 OPERATOR MANUAL
3-64
Published 03-29-17, Control # 064-23
Table 3-7 Digital Input Reference Chart
CAN Packet
Number
Item Description
(Node Number)
CAN Packet
Number
Item Description
(Node Number
)
CAN36-1-1 Handle (H4) Direction Signal (N2) CAN84-4-64 Maximum Jib Angle Limit (N20)
CAN36-1-2 Handle (H3) Direction Signal (N2) CAN84-4-128 Block-Up Limit 3 - Fixed (N20)
CAN36-1-4 Swing Holding Brake Switch (N2) CAN85-2-64 Block-Up Limit 3 (N21)
CAN36-1-8 Swing Handle Direction Signal (N2) CAN85-2-128 Block-Up Limit 4 (N21)
CAN36-1-16 Air Conditioning - On (N2) CAN92-3-4 Front Drum (Drum 1) Park Switch (N1)
CAN36-1-32 Cab Tilt - Down (N2) CAN92-3-16 Rear Drum (Drum 2) Park Switch (N1)
CAN36-1-128 Seat Safety Switch (N2) CAN92-3-64 Travel Park Switch (N1)
CAN36-2-1 Left Track Direction Signal (N2) CAN92-3-128 Mast Cylinders Retract Switch (N1)
CAN36-2-2 Handle (H1) Direction Signal (N2) CAN92-4-1 Display Enter Switch (N1)
CAN36-2-4 Handle (H2) Direction Signal (N2) CAN92-4-2 Confirm Switch (N1)
CAN36-2-8 Right Track Direction Signal (N2) CAN92-4-4 Limit Bypass Switch (N1)
CAN36-2-16 Cab Tilt - Up (N2) CAN92-4-8 Display Scroll Up Switch (N1)
CAN36-2-32 Travel Cruise (N2) CAN92-4-16 Jib Up Limit Bypass Switch (N1)
CAN36-2-64 Travel Speed (N2) CAN92-4-32 Display Scroll Down Switch (N1)
CAN38-1-64 Remote Control - Back Hitch Pins (N3) CAN92-5-4 DPF Regen Inhibit (N1)
CAN40-1-64 Gantry Maximum Angle Limit (N4) CAN92-5-16 DPF Regen Initiate (N1)
CAN55-1-64 Left Swing Limit Switch (N5) CAN92-5-32 Engine Run/Start (N1)
CAN55-1-128 Right Swing Limit Switch (N5) CAN92-6-4 Display 1 (N1)
CAN84-2-64 Block-Up Limit 2 - Upper Point (N20) CAN92-6-16 Display 2 (N1)
CAN84-2-128 Block-Up Limit 1- Lower Point (N20) CAN92-6-64 Display Exit Switch (N1)
CAN84-4-32 Minimum Jib Angle Limit (N20) CAN92-6-128 Load/Luffing (Drum 3) Park Switch (N1)
To Next Page
Loading...
Need help?
General
