Grove Published 07-06-2017, Control # 406-03 5-1
CD5520/YB5520 OPERATOR MANUAL ATTACHMENTS
SECTION 5
ATTACHMENTS
SECTION CONTENTS
Pivoting Boom Head. . . . . . . . . . . . . . . . . . . . . . . . 5-1
Boom Head Positions . . . . . . . . . . . . . . . . . . . . . . 5-1
Changing the Boom Head Position
(No Boom Extension) . . . . . . . . . . . . . . . . . . . . . . 5-3
Adjusting the Boom Extension Offset . . . . . . . . . . 5-4
Hoist Block . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-5
Removing The Hoist Block . . . . . . . . . . . . . . . . . . 5-5
Installing the Hook Block . . . . . . . . . . . . . . . . . . . 5-5
Boom Extension . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-5
Attaching the Boom Extension . . . . . . . . . . . . . . . 5-5
Manually Extendable Jib (Optional) . . . . . . . . . . 5-10
Stowing the Boom Extension. . . . . . . . . . . . . . . . 5-11
Searcher Hook Assembly . . . . . . . . . . . . . . . . . . . 5-13
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-13
Removal. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-13
Down Haul Weight. . . . . . . . . . . . . . . . . . . . . . . . . 5-14
Installing the Down Haul Weight . . . . . . . . . . . . . 5-14
Removing the Down Haul Weight . . . . . . . . . . . . 5-14
Installing Cable On The Hoist. . . . . . . . . . . . . . . . 5-15
Wire Rope Wedge Socket . . . . . . . . . . . . . . . . . . . 5-16
Reeving. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-18
Reeving for 4-part Line . . . . . . . . . . . . . . . . . . . . 5-18
PIVOTING BOOM HEAD
Boom Head Positions
The pivoting boom head can be adjusted to four angled
positions, in addition to 0°. Two of which are used when there
is no boom extension attached and two when a boom
extension is attached.
Positions When No Boom Extension Is Attached
The plus 40° and plus 80° boom head positions (Figure 5-1)
can be used when there is low head room clearance and a
smaller profile boom head is needed.
Positions When Boom Extension Is Attached
The minus 15° and minus 30° boom angles are used to offset
the boom extension. See Figure 5-2.
Reference Only