BEFORE USINGTHE TABLE SAW WiTH LASER LiNE
WARNING: DO NOT OPERATE YOUR TABLE SAW UNTIL IT IS COMPLETELY
ASSEMBLED AND INSTALLED ACCORDING TO THE INSTRUCTIONS
]
1. ALWAYS USE THE SAW BLADE GUARD, splitter and anti-kickback pawls for every
operation for which they can be used, including through-sawing. Through-sawing
operations are those in which the blade cuts completely through the workpiece when
ripping or cross-cutting.
2. ALWAYS HOLD WORK FIRMLY against the mitre gauge or rip fence.
3. USE A PUSH STICK when required, especially when ripping narrow stock. Refer to
ripping applications in the instruction manual where the push stick is covered in detail. A
pattern for making your own push stick is included.
4. NEVER PERFORM ANY OPERATION "FREE HAND"= this means using only your
hands to support or guide the workpiece. Always use either the rip fence or the
mitre gauge to position and guide the workpiece.
WARNING: FREE HAND CUTTING IS THE MAJOR CAUSE OF KICK=BACK &
FINGER/HAND AMPUTATIONS.
5. NEVER STAND or have any part of your body in line with the path of the saw blade.
Keep your hands out of the saw blade path.
6. NEVER REACH behind or over the table saw for any reason.
7. REMOVE the rip fence when cross cutting.
8. DO NOT USE a moulding head with this saw.
9. FEED WORK iNTO THE BLADE against the direction of rotation only.
10. NEVER use the rip fence as a cut-off gauge when cross-cutting.
11. NEVER ATTEMPT TO FREE A STALLED SAW BLADE without first turning the table
saw OFF and unplugging the table saw. Immediately, turn the power switch OFF to
prevent motor damage.
12. PROVIDE ADEQUATE SUPPORT to the rear and the sides of the work table for long or
wide workpieces.
SAVE THESE SAFETY INSTRUCTIONS
To Next Page
Loading...
Need help?
General
