#
Screw on the fastener of AdBlue
®
r
ell canis-
ter 4.
#
Screw the disposable hose 3 onto the open-
ing of AdBlue
®
rell canister 4 until hand-
tight.
#
Screw the disposable hose 3 ont
o the ller
neck of the vehicle until hand-tight.
#
Li up and tip A
dBlue
®
rell canister 4.
The lling process stops when the AdBlue
®
tank is completely full.
AdBlue
®
rell canister 4 can be removed
when it has been only partially emptied.
#
Unscrew and close the disposable hose 3
and A
dBlue
®
rell canister 4 in reverse
order.
#
Replace AdBlue
®
ller cap 2 and tur
n it
clockwise until it audibly engages.
#
Close fuel ller ap 1.
#
Switch on the vehicle for at least 60 seconds.
%
If the vehicle could not be started as the
A
dBlue
®
tank was empty, it can take up to
60 seconds for the rell to be detected.
#
Start the vehicle.
%
Avoid storing AdBlue
®
r
ell containers perma-
nently in the vehicle.
Charging the high-voltage battery (plug-in
h
ybrid)
Notes on charging the high-voltage battery
*
NOTE High-v
oltage battery damage due to
leaving the vehicle idle for lengthy periods
of time
Lithium-ion batteries experience a natural self-
disc
harge.
Exhaustive discharging can therefore occur if
the vehicle is idle for several months. This can
damage the high-voltage battery.
#
To avoid damage, please observe the fol-
lowing recommendations when handling
the high-voltage battery.
*
NOTE A
ccelerated ageing of the high-volt-
age battery due to not observing the fol-
lowing recommendations
As a result of its basic characteristics, the
s
torage capacity of and the amount of energy
available from the high-voltage battery decrea-
Driving and parking
213
To Next Page
Loading...
Need help?
General
