Section 3 - Contextual Data
90-8M0074776 eng MAY 2013 Page 21
Scroller Bar Icons
Icon Description
a
Temperature–displays engine and environment temperature values: oil, water, fuel, air (manifold.) Available
information is power‑package dependent.
b
Pressure–displays engine pressure values: water, oil, fuel, boost. Available information is power‑package
dependent.
c Voltage–displays battery values for all engines.
d Tanks–displays the vessel's onboard tanks data: fuel, water, waste, oil (two‑cycle only), capacity.
e
Trip Log–displays recorded trip data: total distance, total time, average speed, average fuel consumption. Trip log
recorded data can be erased and set to zero.
f
Generator–displays data the generator can send through a NMEA 2000 or J1939 protocol control area network:
current state (run/stop), voltage (AC/DC), hertz, hours, oil pressure, water temperature.
g Smart Tow–activates Smart Tow profiles for selection. Profiles can be modified.
h Troll Control–activates low‑speed engine control. Can be used to control engine RPM.
I
Fuel Management–displays fuel system statistics: current economy, average economy, volume use per hour,
total capacity, fuel used.
j Autopilot–displays autopilot data
k
Eco–displays information to guide the operator to the best trim position and engine speed to achieve the best fuel
economy.
l
Navigation–displays data relating to installed navigation system: compass heading, longitude and latitude, time to
waypoint (TTW,) bearing to waypoint (BTW,) distance to waypoint (DTW,) course over ground (COG).
m Expand–paginates through the selected data screens.
n
Trim and Tabs–displays drive trim position and position of tabs. A sensor must be installed on the tabs for this
function to display information.
o
Performance–displays advanced performance data: peak performance (RPM/speed), inches per revolution of the
propeller.
p
Engine Data–displays additional engine information: manifold temperature, throttle percent, engine load, manifold
boost pressure. Available information is power package dependent.
q
Cruise Control–activates cruise control. Allows the user to control the vessel with the engine RPM or vessel
speed. Vessel speed control requires a paddle wheel sensor or GPS.
r
Settings–main location where data can be turned on or off, modify sensor data tolerance ±, select preferred
displayed values (metric/English/nautical), reset to factory default. Note—A reset to factory default will erase all
customized settings.
To Next Page
Loading...
Need help?
General
