This will show a screen with devices and data sensors associated with the engine and vessel. Depending on the vessel's power
package, some of the options will not apply. Press the Enter button to show a selection of sources for transmitting a device or
sensor's data. Use the Up arrow and Down arrow buttons to scroll through selections.
Within the Device list option, highlighting and selecting the Refresh tab can be helpful if a new device has been installed.
Refresh will query the network and display all of the devices that are properly responding to the query.
Selecting Diagnostics shows the operator the current activity on all of the active CAN buses. Transmit and receive rates can be
viewed in real time. This feature can be helpful in troubleshooting network problems.
Simulate
Simulate is used at a dealer level, to show consumers the display characteristics of the VesselView. When the unit is in
Simulate mode, the data shown on the screen should not be used as navigation information. All data shown during Simulate is
randomly generated.
Section 3 - Main Menu Selections
Page 48 90-8M0124182 eng DECEMBER 2017
To Next Page
Loading...
Need help?
General
