Miele H 2465 BP User Manual

Installation
*INSTALLATION*
79
Installing the oven
For safety reasons, the oven may
only be used when it has been fully
installed.
The oven requires a sufficient supply
of cool air for efficient operation. The
required supply of cool air must not
be excessively heated by other heat
sources (e.g. solid fuel stoves).
The following must be observed
when installing the appliance:
Make sure that the shelf that the
oven sits on does not touch the wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
 Connect the oven to the electrical
supply.
Carrying the oven by the door handle
could damage the door.
Use the recessed grips on the side of
the housing to carry the appliance.
It is a good idea to remove the door
(see “Cleaning and care” – “Removing
the door”) and the accessories before
installing the appliance. This makes
the oven lighter when you push it into
the housing unit and you do not run
the risk of lifting it by the door handle
by mistake.
 Push the oven into the housing unit
and align it.
 Open the door, if you have not
removed it.
 Use the screws supplied to secure
the oven to the side walls of the
housing unit.
 Refit the door if necessary (see
“Cleaning and care” – “Fitting the
door”).

Miele H 2465 BP Specifications

General

Grill	-
Oven size	Large
Oven type	Electric
Top heating	Yes
Number of ovens	1
Total oven power	- W
Total oven(s) interior capacity	76 L
Cord length	1.5 m
Control type	Rotary, Touch
Handle color	Stainless steel
Product color	Black, Stainless steel
Control position	Front
Appliance placement	Built-in
Clock type	Electronic
Current	16 A
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Energy efficiency scale	A+++ to D
Package depth	689 mm
Package width	671 mm
Package height	747 mm
Package weight	54000 g

Weight and Dimensions

Depth	568 mm
Width	595 mm
Weight	47000 g
Depth with door open	1020 mm
Installation compartment depth	550 mm
Installation compartment height	590 mm
Installation compartment width (min)	560 mm