Special features in the programme sequence
39
Spinning
Final spin speed
When a programme is selected, the
maximum spin speed for this wash
programme is shown in the display.
You can reduce the final spin speed.
However, you cannot select a final spin
speed higher than that shown in the
chart.
Interim spin
There is a spin cycle after the main
wash and between the rinses. A
reduction in the final spin speed will
also reduce the interim spin speed
accordingly.
Deselecting the interim spin and the
final spin
Select the programme setting Spin
speed 0.
After the last rinse cycle, the water will
be pumped away and the anti-crease
phase will switch on.
Anti-crease
At the end of the programme, the drum
continues to turn at intervals for up to
30minutes to help prevent creasing.
The door can be opened at any time
during the anti-crease phase.
There is no anti-crease phase at the
end of some programmes.
To Next Page
Loading...
Need help?
General
