Miele PWM 507 Hygiene User Manual

Problem solving guide
46
Programme cancellations and fault messages
Problem Possible cause and remedy
 Drainage fault. Clean
drain filter and pump.
Check the drain
hose.
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
 Clean the filters and the drain pump.
 The maximum drain height is 1m.
 Water intake fault.
Turn on the tap.
The water inlet is blocked or restricted.
 Check whether the tap is turned on properly.
 Check whether the inlet hose is kinked.
The water pressure is too low.
 Switch on the Low water pressuresetting (see
“Supervisor level - Low water pressure”).
The filters in the water inlet are blocked.
 Clean the filters (see “Cleaning and care - Cleaning
the filters”).
 Waterproof system
activated
The water protection system has reacted.
 Turn off the tap.
 Call Miele.
 Disinfection
temperature not
reached
The required temperature was not reached during the
disinfection programme.
 The washing machine has not carried out the
disinfection cycle correctly.
 Start the programme again.
 Fault F. If restart
fails, call Miele.
There is a fault.
 Disconnect the washing machine from the mains
electricity supply.
 Wait at least 2 minutes before reconnecting the
washing machine to the electricity.
 Then switch the washing machine on again.
 Start the programme again.
If the fault message appears again, contact Miele.

Miele PWM 507 Hygiene Specifications

General

Brand	Miele
Model	PWM 507 Hygiene
Category	Washer
Language	English