Miele PWM 507 Hygiene User Manual

Supervisor level
73
Low water pressure
If the water pressure is below 100kPa
(1bar), the programme will be
cancelled and the fault message
Check water inlet will appear.
If the on-site water pressure cannot be
increased, activating the Low water
pressure setting will prevent the
programme from being cancelled.
Factory setting: Off
Empty sensor
A suction lance contact can be used
to detect whether external liquid
detergent containers are empty. A
message will appear if a container is
empty.
– Off (factory seeting)
The empty container sensing function
is switched off.
– Normally open contact
The siphons are equipped with a
normally open contact.
– Normally closed contact
The siphons are equipped with a
normally closed contact.
Early warning counter
An internal counter reports when an
external dispenser container is almost
empty. The counter in question then
has to be reset.
Water level Cottons
In the Cottonsprogramme, you can
increase the water level for the main
wash.
– + 0 mmWS (factory setting)
– + 10 mmWS
– + 20 mmWS
– + 30 mmWS
Water level Minimum iron
In the Minimum ironprogramme, you
can increase the water level for the
main wash.
– + 0 mmWS (factory setting)
– + 10 mmWS
– + 20 mmWS
– + 30 mmWS
Pre-wash temp. Cottons
In the Cottonsprogramme, you can
select the temperature for the pre-
wash.
– 30°C (factory setting)
– 35°C
– 40°C
– 45°C

Miele PWM 507 Hygiene Specifications

General

Brand	Miele
Model	PWM 507 Hygiene
Category	Washer
Language	English