Passport V™ Service Manual 0070-10-0705 3 - 15
Repair Information Disassembly Instructions
3.5.15 Removal of the NIBP Assembly
1. Remove the multi-parameter board assembly as stated in “Removal of the Multi-
parameter Board Assembly” on page 3-10.
2. Unplug the tubing from the NIBP gas nipple.
3. Disconnect the NIBP communication cable from the NIBP board.
4. Unfasten the screws that secure the NIBP assembly to the multi-parameter board
installation frame.
5. Remove the NIBP assembly.
FIGURE 3-24 Remove the NIBP assembly
3.5.16 Removal of the Recorder Assembly
1. Remove the two screws that secure the recorder.
2. Release the two clips and pull out the recorder.
FIGURE 3-25 Remove the recorder assembly
3. Disconnect the recorder cable.
4. Remove the recorder.