Passport V™ Service Manual 0070-10-0705 3 - 53
Repair Information Installation Menu
3.17 Installation Menu
3.17.1 Installation Mode
FIGURE 3-69 Installation Menu
The following items are set through the Installation Mode menu: Language, Date Format,
Time Format, NIBP Timeout, Temperature Units, Weight Units, Height Units, CO
2
Units, ECG
Standard, Notch Filter, ESU Filter, SpO
2
Sensor Off Audio, SpO
2
Tones, Enable Arrhythmia
All Off Selection, Apnea Latch, Enable Silence All Permanent Selection, Auxiliary Output,
Nurse Call Mode, Set up Serial Port 1, Set up Serial Port 2, Copy Monitor Defaults to
Storage Device, Copy Monitor defaults from Storage Device, Reboot in demo mode, Restore
factory defaults, Advanced Installation Setup, Change Password, and Options.
1. Enter Installation Mode by pressing and holding the Discharge key while powering on
the monitor.
2. Set each item as necessary. The operation of the menu is the same as that of the normal
operating mode. To save all of the selected settings, choose Save Current before exiting
this menu. To access the normal operation screen, power the unit OFF and ON again.
To Next Page
Loading...
Need help?
General
