Mindray VS-900 Service Manual

8-3
8.1.3 Upgrading NIBP
List of upgrade package:
 An NIBP valve;
 A pump;
 Two cable ties;
 A cable between NIBP module and power management board;
 A parameter connector panel assembly; and,
 Two M3×6 screws
Disassemble the main bracket assembly and parameter connector panel assembly as
described in 6.3 Disassembling the Main Unit , assemble the NIBP valve and pump onto the
main bracket assembly, and then assemble the new connector panel assembly, cables, and
tubes together into the main unit.
8.1.4 Upgrading Temp
List of upgrade package:
 A Temp module with cables; and,
 Two M3×6 screws.
Remove the decorative cover from the Temp module connector. Install the Temp module
onto the main unit as described in 6.5 Disassembling the SmarTempTM Module (Optional).
8.1.5 Enabling Parameter Functions
1. Select [Main
→
][Maintenance >>
→
][Factory Maintenance >>
→
] enter the required
→
password [Ok
→
][Device Config. >>].
2. In the prompt menu, check the upgraded functions.
3. Click
to save the changes and quit the menu.
4. Restart the monitor and the software for upgraded parameters are enabled.
8.1.6 Upgrading Wireless Network Function
List of upgrade package:
 Antenna sleeve
 Wi-Fi antenna
 Carrier board of wireless module (PCBA)
 Radio module support IEEE 802.11a/b/g/n
 Wi-Fi label
 Three cross pan head screw M2X4

Mindray VS-900 Specifications

General

Brand	Mindray
Model	VS-900
Category	Monitor
Language	English