5-8
or some parameters
cannot be used
Converter board
defective inside the
module
Replace corresponding converter board.
"XX" indicates the configured modules, such as NIBP, SpO
2
and Temp.
5.6.13 THJ79JU Infrared Ear Thermometer Module Problems
Symptoms Possible Cause Troubleshooting
Error 5~9, the system
is not functioning
properly.
Unload the battery, wait for 1 minute and
repower it. If the message reappears, contact
the retailer for service.
A measurement is
taken before device
stabilizes.
Wait until all the icons stop flashing.
The ambient
temperature is
beyond the range of
10℃ - 40℃ (50℉
-104℉).
Keep the thermometer from operating for at
least 30 minutes at a temperature of 10℃ -
40℃(50℉ -104℉).
Temperature taken is
higher than +42.2℃
(108℉).
Check the integrity of the probe cover and
take a new temperature measurement.
Temperature taken is
lower than +32℃
(89.6℉).
Make sure the probe cover is clean and take a
new temperature measurement.
5.6.14 Genius
TM
2 Infrared Ear Thermometer Module Problems
Symptoms Possible Cause Troubleshooting
Temperature reading
unusually high
The installed probe
cover is with
non-smooth
membrane on the
thermometer.
Check the probe cover for tears or gaps.
Temperature reading
unusually low
Cerumen plugs or
impactions containing
debris can lower the
temperature
measurement by
several tenths of a
degree.
Check the probe cover and thermometer tip
for obstructions. Check the patient ear canal
for obstructions.
Display blank Poor contact. Check tethered connectivity.
To Next Page
Loading...
Need help?
General