Mindray VS-900 Service Manual

3-1
3 Equipment Installation
3.1 Unpacking the Equipment
Open the package and take out the packing list. Check that all the articles included in the
packing list are available and the quantity and specification are correct. Make sure that:
 All the optional parts purchased by the customer shall also be checked.
 Notify the supplier if provided components are not correct as compared to the packing
list.
 In case of damage during transportation, keep the packing material and notify the
supplier immediately.
 Keep the packing material till new equipment is accepted.
3.2 Preparation for Installation
3.2.1 Preparation for Installation Site
1. Ensure that the site meets all safety, environmental and power requirements.
2. Check that required power sockets are available.
3. Check that a network connector is available if the equipment needs to be connected to
network.
3.2.2 Environmental Requirements
To avoid explosion hazard, do not use the equipment in the presence of flammable
anesthetics, vapors or liquids. The environment where the equipment will be used should be
reasonably free from vibration, dust and corrosive substances. If these conditions are not
met, the system may not function normally.
The environmental specification is as follows:
Main Unit
Item
Temperature (℃)
Relative humidity
(noncondensing)
Altitude (kPa)
Operating
environment
0 to 40 (without Temp module)
5 to 40 (with SmarTemp module)
16 to 33 (with Genius 2 Temp module)
16 to 40 (with Exergen Temp module)
15% to 95% 57.0 to 107.4
Storage
environment
-30 to 70
-25 to 55 (with Genius 2 Temp module)
-20 to 50 (with Exergen Temp module)
10% to 95% 16.0 to 107.4

Mindray VS-900 Specifications

General

Brand	Mindray
Model	VS-900
Category	Monitor
Language	English