4-1
4 Testing and Maintenance
4.1 Introduction
To ensure the equipment always functions normally, qualified service personnel should
perform regular inspection, maintenance and test. This chapter provides a checklist of the
testing procedures for the equipment with recommended test equipment and frequency.
The service personnel should perform the testing and maintenance procedures as required
and use appropriate test equipment.
The testing procedures provided in this chapter are intended to verify that the equipment
meets the performance specifications. If the equipment or a module fails to perform as
specified in any test, repairs or replacements must be done to correct the problem. If you
have any question, contact our Customer Service Department.
CAUTION
All tests should be performed by qualified service personnel only.
Care should be taken to change the settings in [User Settings >>] and [Factory
Maintenance >>] menus to avoid loss of data.
Service personnel should acquaint themselves with the test tools and make sure
that test tools and cables are applicable.
4.1.1 Test Equipment
See the following sections.
4.1.2 Test Report
Upon the completion of the tests, the table of preventative maintenance test reports and
the table of maintenance test reports in this chapter should be kept properly.
4.1.3 Preventative Maintenance
Below are preventative maintenance tests which need to be performed on the monitor. The
recommended frequency of preventative maintenance is at least once per year. See the
following sections for detailed maintenance procedures.
Visual inspection
NIBP test
To Next Page
Loading...
Need help?
General