Minelab F3Ci Service Manual

F3Ci Service Manual
_______________________________________________________________________________________________________________________
26
• Gently lift the main PCB out of the detector body.
b.
The main PCB can now be replaced.
3.3.2 Installing the Main PCB.
a. Having opened the detector body and removed the main PCB, install a serviceable main
PCB as follows:
• Place the detector on its left side in a clean well lit area.
•
Lower the main PCB into the detector, gently position the main PCB flat inside the
detector body.
• Gently slide the main PCB rearward towards the battery compartment so that the
ends of the main PCB insert into the locating slots in the detector body.
Figure 35
: Lifting Main PCB Out of Detector
Figure 36
:
Main PCB

Minelab F3Ci Specifications

General

Brand	Minelab
Model	F3Ci
Category	Metal Detector
Language	English