Minelab F3Ci Service Manual

F3Ci Service Manual
_______________________________________________________________________________________________________________________
35
•
Separate the pivot lower shaft from the pivot coil yoke. Gently feed the coil cable
through the pivot lower shaft removing the pivot shaft from the coil cable. Do not
stretch the coil cable.
•
Pull the pivot coil yoke off the coil and carefully thread the coil cable through the
pivot coil yoke. If required remove the O-ring from the coil.
3.4.5 Fitting the Coil Pivot
a.
To fit the coil pivot, firstly remove the coil from the detector as described in section
Figure 56: Removing Pivot Coil Yoke
Note: F3Ci Coil
w
ill be black
O
-
Ring
Pivot Coil Yoke
Pivot Lower Shaft
Figure 54
: Removing Pin Coil Pivot
Figure 5
5
: Removing Pivot
Lower
Shaft

Minelab F3Ci Specifications

General

Brand	Minelab
Model	F3Ci
Category	Metal Detector
Language	English