F3Ci Service Manual
_______________________________________________________________________________________________________________________
43
3.5.1
Replacing a Camlock
a. Camlock replacement can be achieved as follows:
•
Open the camlock lever and using a pin punch and hammer drive the camlock pin
out.
•
Once the camlock pin has been removed the camlock pressure block can be removed
and replaced if needed.
Note
When the camlocks are closed they must hold the shafts firmly with no slippage. If the
camlock does not hold the shafts firmly in place then the pressure block should be replaced
.
•
To assemble the camlock, fit the pressure block to the camlock lever.
•
Place the camlock lever with pressure block fitted into position within the camlock
body then press the camlock pin into place.
3.5.2
Removing the Shafts
a.
To remove the shafts from the detector firstly open the detector body as described in
Section 3.1 – Opening the Detector Body. Once completed:
•
Lift the shafts clear of the detector.
Figure 70: Removing Camlock Pin
Figure 71: Fitting Camlock Pin
To Next Page
Loading...
Need help?
General
