3-32
Installing the solenoid valve set(1E-VD01/VD01E/VD02/VD02E)
3Installing the option devices
3) Connect one of the two (φ6) pneumatic hoses in section A --the one marked "AIR IN" --to the quick
coupling (port P) <9> of the solenoid valve <6>. The primary air flow can now be supplied from the pneumatic
port at the base.
4) Connect the hose marked "1" to port A <7> on the primary solenoid valve <6>.
Connect the hose marked "2" to port B <8> on the primary solenoid valve <6>.
If you are using the double type valves (1E-VD02/VD02E), you need to do the following:
Connect the hose marked "3" to port A <11> on the secondary solenoid valve <10>.
Connect the hose marked "4" to port B <12> on the secondary solenoid valve <10>.
5) Connect the GR1 plug protruding from the primary solenoid valve <6> to the connector GR1.
Connect the GR2 plug protruding from the primary solenoid valve <6>to the connector GR2.
If you are using double type valves (1E-VD02/VD02E),
Connect the GR3 plug protruding from the secondary solenoid valve <10> to the connector GR3.
Connect the GR4 plug protruding from the secondary solenoid valve <10 >to the connector GR4.
6) When you have completed the installation, reinstall the shoulder cover (B) <1> to its original position, and be
careful not to entangle the cables when you do so.
The connections after the installation appear as in Table 3-1 for single type valves, hand 2 is not applicable.
Table 3-1：Solenoid valve ports and hoses: Correspondence of couplings and hand ports
Hand Hand port
Fore arm
coupling No.
Hose number
Solenoid valve
port
Solenoid valve
used
Hand 1
OPEN 11A
First set
CLOSE 2 2 B
Hand 2
OPEN 3 3 A
Second set
CLOSE 4 4 B
To Next Page
Loading...
Need help?
General
