To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...How to troubleshoot no display on Motorola Controller?
If nothing is displaying on the Motorola Controller terminal, first, ensure the system is properly plugged in. If the LEDs are lit, the CPU board should be in the first (leftmost) slot for VMEmodules. Finally, ensure that the system console terminal is configured correctly as described in this manual.
What to do if Motorola 700 Controller board fails tests?
If the Motorola Controller board fails its tests and cannot be corrected, document the problem and return the board for service due to a potential fault in the board hardware or debugging firmware.
What to do if Motorola 700 Controller keyboard/mouse not working?
If the keyboard or mouse input has no effect on the Motorola Controller, recheck the keyboard and/or mouse connections and power. Also, check the board jumpers as described in this manual. Lastly, if you have accidentally activated flow control by pressing a HOLD or PAUSE key, press it again. If that doesn't work, type -Q.
General| Brand | Motorola |
|---|---|
| Model | 700 Series |
| Category | Controller |
| Language | English |
Warns about the danger of explosion if the lithium battery is replaced incorrectly.
Lists and explains the function of various jumper headers for board configuration.
Step-by-step instructions for installing the MVME162LX into a VME chassis.
Covers 162Bug installation, startup, autoboot, ROMboot, and network boot procedures.
Explains entering commands, terminal I/O control, command syntax, and parameters.
Summarizes the available 162Bug debugger commands and their syntax.
Provides simple troubleshooting steps for CPU board startup difficulties.
