Identifying Status Indicators
English
24
LED Indicators in Surveillance Mode†
For covert operation, the LED can be preprogrammed to be
turned off at specific zone or channel. During operation in these
zone or channel the LED blinking is not seen, instead Voice
Announcement can be used to hear and confirm the operation
status.
Hence, It is recommended to duplicate the channel
programming into a separate zone and have the associated
Voice Announcement tied to zone to help indicate the LED on/
off state, for example “Light Off” “Zone 1”. Using zone control in
this case eases going into and out of the zone or channel
preprogrammed with the LED on/off setting.
Solid green
Short blinking blue
with long interval
Radio is reading or upgrading by CPS.
–
Blinking blue three
times
Bluetooth is powering on or off.
– Slow Blinking blue Radio is waiting to be paired when no device is connected with radio in Bluetooth.
–
Blinking blue at
heartbeat pace
Radio is connected with at least a device in Bluetooth link.
–
Solid blue for two
seconds
Bluetooth device is connected.
Bluetooth device is disconnected.
– Blinking blue Radio is clearing Bluetooth pairing information.
–
Rapid blinking blue
for two seconds
Radio fails to connect or disconnect from a device.
– Solid blue Radio is powering up with Option Board error.
Note: No LED indication occurs when your radio receives a clear (non-secured) transmission in trunking Mode.
Transmit/Receive LED Bluetooth LED Status
APX_3000_M1.book Page 24 Thursday, November 7, 2013 4:48 PM
To Next Page
Loading...
Need help?
General
