Advanced Features
English
37
Using the Dynamic Regrouping Feature (Trunking
Only)†‡
This feature allows the dispatcher to temporarily reassign
selected radios to a particular channel where they can
communicate with each other. This feature is typically used
during special operations and is enabled by a qualified radio
technician.
You will not notice whether your radio has this feature enabled
until a dynamic regrouping command is sent by your dispatcher.
Note: If you try to access a zone or channel that has been
reserved by your dispatcher as a dynamically
regrouped mode for other users, an invalid tone
sounds.
Procedure:
1 When your radio is dynamically regrouped, it automatically
switches to the dynamically regrouped channel. A “gurgle”
tone sounds and the display shows the dynamically
regrouped channel’s name.
2 Press the PTT button to talk. Release PTT button to listen.
When your dispatcher cancels dynamic regrouping, your radio
automatically returns to the zone and channel that you were
using before your radio was dynamically regrouped.
Requesting a Reprogram (Trunking Only)†‡
This feature allows you to notify your dispatcher when you want
a new dynamic regrouping assignment.
Procedure:
1 Press the preprogrammed Reprogram Request button to
send reprogram request to your dispatcher.
2 The display alternates between RPGM and PLS WAIT.
3 If you hear five beeps, your dispatcher has acknowledged
the reprogram request. The display shows ACK RCVD.
OR
If your dispatcher does not acknowledge the reprogram
request within six seconds, a low-pitched alert tone sounds
and the display shows NO ACK.
APX_3000_M1.book Page 37 Thursday, November 7, 2013 4:48 PM
To Next Page
Loading...
Need help?
General
