Getting Started 1 - 13
Figure 1-17
Routing RS309 Scanner Cable from Hip to Hand
Connecting a Scanner
The RS309, RS409 and RS419 scanners and the RS507 imager can be used with the wearable terminal. See
RS309 Scanner on page 5-10 and RS409/RS419 Scanner on page 5-8 for procedures for connecting the
scanner to the wearable terminal. Refer to the RS507 Product Reference Guide for procedures for connecting
the imager to the wearable terminal.
Starting the Wearable Terminal
Press the Power button to turn on the wearable terminal. If the wearable terminal does not power on, perform
a cold boot. See Resetting the Wearable Terminal on page 2-17.
WT41N0 Boot Up
When the WT41N0 is powered on for the first time the splash screen (Figure 1-18) appears for a short period
of time followed by the Start Up window on non-touch configurations and the calibration screen on touch
enabled configurations.
NOTE When a battery is fully inserted in a wearable terminal for the first time, upon the wearable terminal’s first
power up, the device cold boots and powers on automatically.
To Next Page
Loading...
Need help?
General