Native Instruments MASCHINE STUDIO Getting Started

6.3.1 Recording Modulation
Let’s record some simple modulation for the effect parameter of your choice.
6.3.1.1 Recording Modulation in the MASCHINE Software
If you take a closer look at the knobs in the Parameter area you will notice they have an outer
ring. This ring serves for recording modulation:
►
To record modulation, check that your song is playing, click the outer ring of the desired
knob and then drag it vertically.
Recording modulation for a parameter.
→
You will note that the colored ring usually representing the current value of the parameter
turned to a colored little dash. This dash follows the movements you just recorded.
To remove modulation, do the following:
►
To remove the modulation for a parameter, right-click ([Ctrl] + click on Mac OS X) on its
outer ring.
→
The dash in the outer ring turns back to the usual indicator for unmodulated parameters.
6.3.1.2 Recording Modulation using the Controller
To automate a parameter from your controller:
1. Check that the PLUG-IN button is lit — if not, press it to enter Control mode.
2. Press PLAY to start the sequencer.
3. Press button 5 or 6 to select the plug-in slot containing the effect you want to automate.
4. Press and hold AUTO, and turn Knob 1–8 under the displays corresponding to the param-
eter that you want to automate.
Applying Effects
Modulating Effect Parameters
MASCHINE STUDIO - Getting Started - 98

Native Instruments MASCHINE STUDIO Specifications

General

Brand	Native Instruments
Model	MASCHINE STUDIO
Category	Recording Equipment
Language	English