EasyManuals Logo
Home>Netafim>Water Filtration Systems>SCREENGUARD

Netafim SCREENGUARD User Manual

Netafim SCREENGUARD
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
SCREENGUARD
INSTALLATION AND USER MANUAL
DESCRIPTION
SG1 Smart Bluetooth flush controller
New hardware design, professional properties, and high reliability make the SG1 the most efficient
solution for the management of the SG filter.
Main features
PD based flushing cycle activation
The controller monitors the pressure differential between the inlet and outlet by means of a built-in
PD sensor and triggers flushing cycles accordingly.
Smartphone application
Feature a user-friendly Smartphone application that communicates with the controller via Bluetooth (10
meter range of the controller!)
The application allows:
Monitoring all the parameters of the filter's activity
Reviewing the filter activity history
Setting operational parameters: PD (pressure differential ), PD delay, Flushing interval and operation mode
Starting a flushing cycle
Monitoring battery state
The application interfaces with multiple SG1 controllers, allowing monitor and control of many filters.
Manual flushing cycle activation
An external START button enables manual activation of a flushing cycle.
Endless looping detection
The SG controller monitors the number of consecutive flushing cycles triggered by the PD sensor before
deciding that there is an endless looping problem. The options, controlled and monitored through the
cellular application, are: 1-10 or “no,” ignore the looping problem.
The flush controller does not require any adjustment, it is entirely factory adjusted for best operation.
PD (pressure-differential) is set to 5 meters (0.5 bar)
PD delay is set to 5 seconds
Flushing interval is set to 4 hours
The operation mode is set to Time & PD
The controller is fully functional with or without the cellular application.
Batteries
The controller is powered by 4 x 1.5v C-size alkaline batteries.
NOTE
If electricity is available at the filter location, the flush controller can be
powered by an external 100-240v AC to 12v DC power supply
[Netafim Cat. No.: 73240-007240 (Europe adaptor)]. (see page 17)
WARNING
When operating the controller with the external power supply, make sure that the battery
compartment is not inside the flush controller (its loose wire ends could cause short-circuit).

Other manuals for Netafim SCREENGUARD

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Netafim SCREENGUARD and is the answer not in the manual?

Netafim SCREENGUARD Specifications

General IconGeneral
BrandNetafim
ModelSCREENGUARD
CategoryWater Filtration Systems
LanguageEnglish

Related product manuals