• Auto — The DNS server specified by Sprint is used.
• Manual — The routing hardware assigns DHCP clients the DNS servers
specified in the DNS 1 and DNS 2 fields. (These fields appear when Manual is
selected.)
Use this option to access a DNS server that provides customized addressing or if
you have a local DNS server on your network.
4. Click Submit.
Enabling Port Forwarding
Before you can use or configure Port Forwarding, you must enable it:
1. Log in to the home page. (See Logging In as an Administrator.)
2. Click Settings > Router > Port Forwarding.
3. Next to Port Forwarding, select Enable.
4. Click Submit.
Enabling Port Forwarding for an Application
You can enable port forwarding for certain application types.
Note: Port forwarding must currently be enabled. (See Enabling Port Forwarding.)
1. Log in to the home page. (See Logging In as an Administrator.)
2. Click Settings > Router > Port Forwarding.
3. In the blank row of the list, enter a Label that describes the application (for example,
“RandomEmailApp”).
4. In the IP field, enter the IP address of the server to be accessed.
5. In the Port field, enter the port used by the application. (If the application uses more
than one port, each port must be forwarded separately.)
6. In the Protocol list, click the protocol(s) used for this application (TCP, UDP).
7. Click the to add this row to the list.
8. Click Submit.
Disabling Port Forwarding for an Application
If you want to stop forwarding any ports, you can remove them from the forwarding list.
Device Settings 97
To Next Page
Loading...
Need help?
General
