.
Hydraulic filter clogged.
Replace hydraulic filter.
Hydraulic system fault. Contact your dealer.
Hydraulic fluid overheating. Fluid level too high or too low. Top up fluid level.
Fluid filter element clogged. Replace filter.
Incorrect flow regulation. Set to lower capacity.
Hoses not joined together
properly.
Wrong male seals. Replace seals with standard
ISO
1
/
2in.
connectors available
from your dealer.
Automatic control valve pin
release mechanism triggered
too soon.
Automatic release pressure
incorrectly set.
Adjust automatic release
pressure setting.
Remote control does not
work.
Hoses not connected correctly. Connect hoses correctly.
Check oil flow in half seals. Actuate control levers; if pro-
blems persist, replace male
half seals.
System overload. Reduce load or use a suitable
cylinder.
To Next Page
Loading...
Need help?
General
