ENGLISH – 23
CONFORMITY
12
12 CONFORMITY
EU Declaration of Conformity
and declaration of incorporation of “partly completed machinery”
Note - The contents of this declaration correspond to declarations in the ofcial document deposited at the registered ofces of Nice S.p.a. and in particular to the last revision available before
printing this manual. The text herein has been re-edited for ed
itorial purposes. A copy of the original declaration can be requested from Nice S.p.a. (TV) I.
298/MC824H Rev: 12 Language: EN
Nice s.p.a.
Via Callalta 1, 31046 Oderzo (TV) Italy
Authorized Person to constitute
technical documentation:
Nice s.p.a.
Comand central a 2 motor 24V dc
MC824H
Refer to the catalog
The undersigned Roberto Griffa, in the role of Chief Executive Ofcer, declares under his sole responsibility that the product described above complies with the provisions
laid down in the following directives:
•
Directive 2014/30/EU (EMC), according to the following harmonized standards: EN 61000-6-2:2005, EN 61000-6-3:2007+A1:2011
The product also complies with the following directives according to the requireme
nts envisaged for “partly completed machinery” (Annex II, part 1, section B):
Directive 2006/42/EC of the EUROPEAN PARLIAMENT AND COUNCIL of 17 May 2006 related to machinery and amending the Directive 95/16/EC (recast).
It is hereby stated that the relevant technical documentation has been compiled in accordance with annex VII B of Directive 2006/42/EC and that the following essential
requirements have been fullled: 1.1.1 - 1.1.2 - 1.1.3 - 1.2.1 - 1.2.6 - 1.5.1 - 1.5.2 -
1.5.5 - 1.5.6 - 1.5.7- 1.5.8 - 1.5.10 - 1.5.11
The manufacturer undertakes to transmit to the national authorities, in response to a reasoned request, the relevant information on the “ partly completed machinery “, while
maintaining full rights to the related intellectual property.
Should the “ partly completed machinery” be put into service in a European country with an ofcial language other than that used in this declaration, the importer is obliged
to arrange for the relative translation to accompany this declaration.
The “partly completed machinery” must not be used until the nal machine in which it is incorporated is in turn declared as compliant, if applicable, with the provisions of
directive 2006/42/EC.
The product also complies with the following standards:
EN 60335-1:2012+A11:2014, EN 62233:2008, EN 60335-2-103:2015
Oderzo,
12/12/2017
Ing. Roberto Griffa
(Chief Executive Ofcer)
To Next Page
Loading...
Need help?
General
