44952001TH Rev.2
5-25
Oki Data CONFIDENTIAL
5. MAINTENANCE MENUS
5.4.6 Colorregistrationadjustmenttest
Thecolorregistrationadjustmenttestisusedforadjustingcolorregistrationorinvestigating
the causes of color misregistration.
Chapter 2 for an overview of color registration adjustment should be followed for recovery
from an error developed by the test.
1. Enter the self-diagnostic mode (level 1) and, until the following message
appears, press [2] or [8].
REG ADJUST TEST
2. Press the [6] button, and the following message appears. Press [2] or [8]
until a
target option appears.
REG ADJUST TEST
REG ADJ EXECUTE
3. Press the OK button, and the displayed test option is performed.
When REG ADJ EXECUTE is executed:
Acolorregistrationadjustmentteststarts(theONLINElampstartsblinking).
When the test ends, the upper display shows the result of the test (OK or an
error name), and the lower display shows ****RESULT.
OK
REG ADJ RESULT
Pressing [2] displays the next test result. Pressing the [8] displays the
preceding test result. Pressing [4] restores the state for step 2.
Remark:While the printer is initialized or issues an alarm or the cover is open, it
displays the following message:
NG
REG ADJ RESULT
Pressing the [#] button during the test cancels the test (turning on the
ONLINE lamp), restoring the state for step 2.
When REG ADJ RESULT is executed:
Same button operations as
used when REG ADJ EXECUTE is executed.
When BLT REFLECT TEST is executed:
A colorregistrationadjustment belt reectiontest starts(the ONLINElamp
starts blinking).
When the test ends, the upper display shows the result of the test (OK or an
error name), the lower display shows ****RESULT.
OK
BLT REFLECT RSLT
Pressing [2] displays the next test result. Pressing [8] displays the preceding
test result. Pressing [4] restores the state for step 2.
Pressing the [#] button during the test cancels the test (turning on the
ONLINE lamp), restoring the state for step 2.
When BLT REFLECT RSLT is executed:
Same button operations as used when BLT REFLECT TEST is executed.
Remark: While the printer is initialized or issues an alarm or the cover is open, it
displays the following message.
NG
REG REFLECT RSLT
4. Repeat steps 2 and 3 when necessary.
5. Press [4] to end the test (the state for step 1 is restored).
Colorregistrationadjustmenttestitems
Display Detail
REG ADJ EXECUTE Executescolorregistrationadjustment.
REG ADJ RESULT Displaystheresultofcolorregistrationadjustment.
BLT REFLECT TEST Judgeswhethercolorregistrationadjustmentbelt
reflection is proper or not
BLT REFLECT RSLT Displaystheresultofcolorregistrationadjustment
beltreectionjudgment.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
